Front and Rear Dash Cam Installation in Perth
Front and rear dash cam installation Perth drivers can book at home or work. The rear camera is the hard part. Its cable runs from windscreen to back glass through headlining, pillars and often a tailgate hinge, so the route is planned for your body type before the installer arrives.
Send the body type, camera and suburb through the quote form for an itemised written quote.
What a Perth front and rear dash cam installation includes
Front camera
mounted behind the mirror, clear of the driver's view and any windscreen sensor housing.
Rear camera
mounted on the inside of the rear glass as standard, with external or canopy mounting where the vehicle, van or ute needs it.
Rear cable route
planned for the body type, run inside the headlining and pillar trim, and passed through the factory conduit at the tailgate or boot hinge.
Power source
a plug-in lead for driving only, or hardwire wiring to ignition and constant fuses when you want parking mode.
Airbag clearance
cable kept clear of curtain airbags along the pillars, as BlackVue's own installation guidance requires.
Handover
front and rear views, date and time stamp, rear mirror-image setting and event locking checked with you, with the workmanship inspected before payment.
The rear-camera routing decision for Perth cars, SUVs and utes
Most installation services quote front and rear dash cams as one price and find out about the car on the day. Here the route is decided first, because the vehicle changes the wiring more than the camera does.
| Body type | Rear cable route | What it means for your install |
|---|---|---|
| Sedan | Headlining to C-pillar, across the parcel shelf or through the boot hinge | Shortest route; boot-lid cameras need a hinge pass-through |
| Hatch and SUV | Headlining to tailgate, through the factory rubber conduit | Cable flexes every time the tailgate opens, so routing and slack matter |
| Wagon | As SUV, with a longer run along the roof | Cable length is checked against the kit before booking |
| Ute | Cabin rear glass, or out to a canopy | Canopy mounting needs a sealed pass-through and an extension cable |
That table is the reason two quotes for the same camera can differ. Say what you drive and the quote already allows for it.
Is a two-channel dash cam right for your Perth driving?
A rear camera earns its place when the risk is behind you. Freeway queues, street parking, shopping centre car parks and the car behind at the lights are the cases it covers.
| You | Front only | Front and rear |
|---|---|---|
| Garage at home, commute on open roads | Enough | Optional |
| Kwinana, Mitchell or Tonkin queues every day | Misses the car behind | Recommended |
| Street or station parking | Misses most parking damage | Recommended with parking mode |
| Rideshare or taxi | Not sufficient | Consider 3 channel with a cabin camera |
Not sure? Describe your week in the quote form and the recommendation comes back with the quote.
Rear cameras on Perth roads and in Perth car parks
Rear-end crashes dominate
At the three Tonkin Highway intersections Main Roads WA studied, more than 80% of 382 crashes over five years were rear-end. Only a rear camera gives clear footage of the vehicle that hit you.
Tinted and privacy glass
Many SUVs and utes have dark rear glass. Some camera makers, including NanoCam Plus and Kapture, advise against mounting directly on tinted windows for their models, so the rear camera position and model are checked together.
Heat on the rear shelf
A rear camera sits in the hottest part of a parked car. In Perth's January and February, with mean maximums above 31°C, supercapacitor rear cameras are the safer choice for parking mode.
Audio and passengers
WA's Surveillance Devices Act 1998 covers private conversations, so if your rear camera also sees the back seat, audio is set with that in mind.
Driving one of these every day? Fill in the quote form with vehicle, camera and suburb and the quote comes back itemised.
How a front and rear dash cam install runs in Perth
-
01
Send the vehicle and camera
Body type is the first thing checked, because it sets the rear route and cable length.
-
02
Quote in writing
Install, hardwire kit if parking mode is wanted, extension cable for canopies, memory card if needed.
-
03
Mobile fit
Front camera mounted, rear cable run through headlining, pillar and conduit, rear camera aligned, power connected.
-
04
Both views tested
Front and rear recordings played back, mirror setting confirmed, parking mode tested locked where fitted.
What to check before you book any Perth two-channel installer
- Will the rear cable go through the tailgate conduit, or be tucked under the boot seal where it chafes?
- Is the rear camera aligned for the whole lane, or just the bumper?
- Does the quote include enough cable for a wagon, ute or canopy?
- Will the mirror-image setting be checked so number plates read correctly?
- Is parking mode a hardwire kit with a cutoff, or just a promise?
- Do you pay before or after both cameras are shown recording?
What changes the cost of front and rear dash cam installation in Perth
Published Perth ranges for two-channel installs are in the cost guide.
- Body type and rear route: a sedan is the shortest job, a ute with a canopy the longest
- Plug-in power or a hardwire kit for parking mode
- Camera supplied by you or with the install
- European cars, hybrids and EVs, which add trim and fuse box time
- A front-only install is simpler; see front dash cam installation if the rear camera is optional for you
Recent installs
Real jobs by our technicians. Hidden cabling, clean mounts.
Frequently asked questions about front and rear dash cam installation in Perth
Where is the rear camera mounted?
On the inside of the rear glass, high and central, as standard. Utes with canopies can have the camera on the canopy glass with a sealed pass-through, and some vehicles suit an external rear camera. The position is confirmed against your camera model and the tint on the glass before fitting.
Does a rear dash cam work through tinted or privacy glass?
Usually, with some loss of night clarity on very dark tint. A few manufacturers advise against mounting their cameras directly on tinted windows, so the installer checks the model's guidance first. Where tint is heavy, an external rear camera or a different mounting spot is discussed before the job.
Can a front and rear dash cam be fitted to a ute?
Yes. The question is where the rear camera goes. Cabin rear glass covers the tray and the car behind at close range; a canopy camera covers the road properly. Canopy installs need an extension cable and a sealed pass-through, which the quote lists.
Will the rear camera record while the car is parked?
Only with parking mode, which needs a hardwire kit or a battery pack. The rear camera then records on impact or motion the same way the front one does, while plug-in power stops when the ignition does. The quote shows both options with the difference in cost.
Do you come to me for a two-channel install in Perth?
Yes. It is a mobile service across Perth and its suburbs; the technician comes to your home or workplace. A rear camera install needs the tailgate or boot open and room along one side of the car, so a driveway, carport or open bay is ideal.
Can you fit the front and rear dash cam I already own?
Yes. Send the brand and model with your car details. The installer checks the rear cable length against your body type, and 4K rear units with thicker cables are flagged, so you know before booking if an extension or hardwire kit is needed.
Book a Perth front and rear dash cam install that suits your car
Tell us the body type and the rest of the quote falls into place. Fill in the quote form with vehicle, camera and suburb. Professional installation is booked at your home or workplace anywhere in Perth, with local pages for Rockingham, Cannington, Joondalup, Midland and Osborne Park, and everything else under dash cam installation Perth.
Last reviewed: November 2026